Connect your order printer by plugging in cords and cables and loading properly sized paper.
This thermal printer is built to print quietly, and works best in areas with normal amounts of heat and humidity.
You can use this printer as an order printer or a payment receipt printer or both.
Unbox your printer
This printer works with Clover systems on the Counter Service and Table Service plans.
You’ll find these items in the box:
-
The Star Micronics TSP143III printer
-
A 5-foot power cable
-
A Cat5 Ethernet cable long enough to go from the printer to the router
You’ll also need:
-
A nearby power source
-
A modem connected to the internet
-
A router to allow multiple internet connections at the same time
Connect the order printer to the network
-
Plug one end of the Ethernet cable into the printer and the other end into the router. Your Clover device should also be connected to this router, either directly or via WiFi. These 4 Clover devices can use either Ethernet or Wi-Fi to send orders and receipts for printing: Station Pro, Station 2, Station, Mini. These 2 Clover devices use Wi-Fi, only, to send orders and receipts for printing: Mobile, Flex.
-
Plug the power cable into the printer.
-
Plug the other end of the power cable into a power source.
-
On the left side of the printer, switch the power on.
Load paper into your printer
-
Make sure the printer is off.
-
Open the paper compartment.
-
Drop in the paper roll so the end comes toward the front of the printer along the printer compartment bottom.
-
Pull out about an inch of paper and close the printer cover.